Tankless Geyser Guide on How it Works
How does it work ? a short tankless story
-
A hot water tap is opened.
-
The opened tap allows cold water to flow through the water heater,
an internal water flow sensor detects this flow.
-
Upon flow detection, the flow sensor sends the activation signal to the computer board.
-
The computer automatically activates the superior three metal heating element,
with heat conducting magnesium powder.
-
As water flows through the stainless steel heating channel,
it absorbs heat from the nickel-chromium heating element.
-
By the time the water exits the heater, it has reached the designated set temperature.
-
When the hot water tap is closed, the water heater automatically turns off.
How does work water flow chart ?
This detailed chart shows you all the specific details on a similar
process when fully installed
It's important that you know the basics of this simple installation pattern, so when a team of ashkco installer arrive at your location, you may have an ideal area that you would like your new igeyser to be installed at.
*Helpful Hints - before installing ashkco's igeyser
-
Make sure that you have a 600kpa pressure relief valve from your previous geyser.
-
All piping must be 15mm (1/2"), the cold line is normally 22mm piping that ok.
-
You must provide us with a 50amp breaker or we can provide one at a cost.
-
If your exciting cable is 2.5mm it must be changed to 6mm thick cable, supplied by us at a cost.